Home Guardian 2.0 – Installation and Initial Setup

Follow these steps to install the Home Guardian 2.0:

1. Make sure the ac power adaptor is securely connected to the back of the device

2. Plug the power adaptor into a direct wall socket that is not connected to a light switch. Avoid any power strips or power cords.

3. After power is supplied, press the power button once to power on the device.  The red power button is located on the back of the device by the power cord.  

4.  The info button will flash amber until it turns solid green.
5. When the device connects to the network, it will verbally state, “Device ready.”