Classic Guardian – Initial Setup and Installation

Follow these steps to install the Classic Guardian:

1. Identify the main home phone (wall jack or modem). 
2. Remove the phone line from the home phone. 
3. Plug it into ‘Line In’ on the back of the device. 
4. Plug the phone line we provided into the “To Phone” on the back of the device. 
5. Plug the other end back into the home phone. 
6. Plug in the power cord and turn the device on using the switch on the bottom of the device. 
7. If the device is installed correctly, the green power light and connection light will be steady green (may take a few seconds). 
8. Check for a dial tone on the home phone.